ENVIRONMENTAL ENGINEER with Security Clearance

Duties This position is located in the Base Environmental Management Office and serves as the installation Environmental Program Manager for the assigned Air National Guard (ANG) installation. An ANG installation can be one with a flying mission or non-flying mission such as a Civil Engineering Red Horse Unit, a Combat Readiness Training Center, or a Geographically Separated Unit with regional geographical responsibilities. Serves as the single point of contact for the initiation, development, and execution of all environmental activities and development of regulatory guidance for an installation and its immediate geographic region, with a collaborative influence extending to a broader area. Regional responsibilities may include, but are not limited to: aircraft mishap response, off site release assessments, air emission estimates, storm water discharge monitoring, and hazardous material shipments. Broader geographic impacts may include, but are not limited to: exporting project solutions, staff assistance visits, compliance assessments, and partnering with other units and intra-agency contacts to address challenges that affect multiple ANG units within or beyond state boundaries. Accomplishes long range environmental planning, budgeting, and programming activities that impacts the installation and the region. Reviews engineering planning and construction documents for environmental considerations as required. Oversees the operations of the Environmental Management Office to include providing limited supervision over any subordinate positions. Supervisory responsibilities will constitute less than 25% of the average work time, thus are not classification impacting. MAJOR DUTIES: 1. Manages a most complex, highly technical environmental management and protection program and serves as the installation's single most knowledgeable expert on DoD, AF, ANG, EPA state specific environmental laws and regulations. Environmental Management duties and responsibilities include, but are not limited to: (1) Hazardous Waste Management; (2) Storm Water Management and Control; (3) Air Quality; (4) Water Quality; (5) Pollution Prevention; (6) Green Procurement; (7) Environmental Restoration Program (ERP); (8) Cultural and Natural Resources Management; (9) Spill Prevention and Response; (10) Environmental Management System; (11) Environmental Impact Analysis Program (EIAP) Management; and (12) Qualified Recycling Program Management. (30%) 2. Manages the entire Planning, Programming, Budget and Execution (PPB&E) for the installations environmental quality (EQ) program area. Additional budgetary responsibilities may include working with the Defense Logistics Agency (DLA) Energy and Environment for recurring environmental costs related to DLA owned fuel systems. Provides financial analysis and planning for Environmental resource requirements, to include planning, programming and execution. Responsible for planning, budgeting, and reporting environmental financial information through directed financial databases. (20%) 3. Prepares and guides implementation of environmental program plans. Environmental program plans can include, but are not limited to (1) Spill Prevention Control and Countermeasures (SPCC) Plan; (2) Storm Water Pollution Prevention Plan (SWPPP); (3) Hazardous Waste Management Plan (HWMP); (4) Air Emissions Inventory (AEI); (5) Green Procurement Plan (GPP); (6) Integrated Pest Management Plan; (7) Refrigerant Management Plan; (8) Cultural or Natural Resources Management Plans; (9) Environmental Management System (EMS) Plans; and (10) Integrated Solid Waste Management Plan. (20%) 4. Serves as an active member of the installation Design Working Group (DWG) accomplishing short term and long range planning in conjunction with Civil Engineering for future military construction and renovation projects. Responsible for ensuring all necessary environmental permits for related construction projects are obtained and necessary plans developed and implemented. (10%) 5. In accordance with the Environmental Impact Analysis Process (EIAP)statutory requirements, the incumbent is responsible for evaluating the environmental impact of construction and renovation projects. Facilitates the decision making process ensuring due consideration is given to the natural environment, social, political, economic, and governance factors and provides a holistic frame work designed for the achievement of sustainable outcomes. (10%) Requirements Conditions of Employment * Federal employment suitability as determined by a background investigation. * May be required to successfully complete a probationary period. * Participation in direct deposit is mandatory. * Must be able to obtain and maintain a Secret Security Clearance Qualifications **This is an Indefinite Tenure position. This position may be terminated at any time with a 30-Day Notice. This position may convert to Permanent without future competition. SPECIALIZED EXPERIENCE : Must have 1-year equivalent to at least next lower grade level experience, education, or training for management, supervision, or performance of (1) planning, designing, construction, and/or maintaining structures and facilities; and (2) investigating, measuring, surveying, and mapping the earth's physical features. Education Degree: professional engineering. To be acceptable, the curriculum must: (1) be in a school of engineering with at least one curriculum accredited by the Accreditation Board for Engineering and Technology (ABET) as a professional engineering curriculum; or (2) include differential and integral calculus and courses (more advanced than first-year physics and chemistry) in five of the following seven areas of engineering science or physics: (a) statics, dynamics; (b) strength of materials (stress-strain relationships); (c) fluid mechanics, hydraulics; (d) thermodynamics; (e) electrical fields and circuits; (f) nature and properties of materials (relating particle and aggregate structure to properties); and (g) any other comparable area of fundamental engineering science or physics, such as optics, heat transfer, soil mechanics, or electronics. If determining basic qualification requirements on a Combination of education and experience, use the Office of Personnel Management Individual Occupational Requirements Paragraph B and add the following 2 subparagraphs under Paragraph B 2 for this Series. B. 2. 1. "Applicants who have passed the EIT examination and have completed all the requirements for either (a) a bachelor's degree in engineering technology (BET) from an accredited college of university that included 60 semester hours of courses in the physical, mathematical, and engineering sciences, or (b) a BET from a program accredited by the Accreditation Board for Engineering and Technology (ABET) may be rated eligible for certain engineering positions at GS-5. Eligibility is limited to positions that are within or closely related to the specialty field of the engineering technology program. Applicants for positions that involve highly technical research, development, or similar functions requiring an advanced level of competence in basic science must meet the basic requirements in paragraph A." B. 2. 2. "Because of the diversity in kind and quality of BET programs, graduates of other BET programs are required to complete at least 1 year of additional education or highly technical work experience of such nature as to provide reasonable assurance of the possession of the knowledge, skills, and abilities required for professional engineering competence. The adequacy of this background must be demonstrated by passing the EIT examination." Functional Manager Selective Factor - Professional Registration: Current registration as a professional engineer by any State, the District of Columbia, Guam, or Puerto Rico. Engineer intern and engineer in training does not meet the selective factor professional registration requirement. If you are using Education to qualify for this position, You must provide transcripts or other documentation to support your Educational claims. To receive credit for Education, you must provide documentation of proof that you meet the Education requirements for this position. Additional information If you are a male applicant who was born after 12/31/1959 and are required to register under the Military Selective Service Act, the Defense Authorization Act of 1986 requires that you be registered or you are not eligible for appointment in this agency ( Register | Selective Service System : Selective Service System (sss.gov) ). * Benefits Help A career with the U.S. government provides employees with a comprehensive benefits package. As a federal employee, you and your family will have access to a range of benefits that are designed to make your federal career very rewarding. Opens in a new window Learn more about federal benefits . Review our benefits Eligibility for benefits depends on the type of position you hold and whether your position is full-time, part-time or intermittent. Contact the hiring agency for more information on the specific benefits offered. How You Will Be Evaluated You will be evaluated for this job based on how well you meet the qualifications above. Once the announcement has closed, your resume and supporting documentation will be used to determine if you meet the qualifications listed on this announcement. If you are minimally qualified, your resume and supporting documentation will be compared to your responses on the assessment questionnaire to determine your level of experience. If you rate yourself higher than is supported by your application package, your responses may be adjusted and/or you may be excluded from consideration for this position. If you are found to be among the top qualified candidates, you will be referred to the selecting official for employment consideration. Your qualifications will be evaluated on the following competencies (knowledge, ski