Specialist - Quality & Continuous Improvement

1 week ago


Kent, United States Rishabh RPO Full time
Job DescriptionJob DescriptionTitle: Quality Specialist
Location: Kent, WA
Duration: 6 Months + Extension
Pay rate: $43/HR on W2

Description:
100% onsite. Shift timing: A Shift - 7 am-3:30 pm PST M-F

Pre-screening questions:
  • What constitutes a non-conformance on a piece of hardware?
  • What is the appropriate process for dealing with a non-conformance once identified?
  • What if any additional information is required from engineering for quality to approve a Use As Is or Repair disposition?
We are looking for an individual who can support the quality initiatives around flight hardware and engine production. This position will directly impact the history of space exploration and will require your dedicated commitment and detailed attention toward safe and repeatable spaceflight.
  • 2+ years' of quality inspection experience in a rocket engine production environment
  • Relevant experience in a start-up environment, transitioning a product from development, through production to operations
  • Relevant experience in AS9145, Advanced Product Quality Planning and Production Part Approval Process
  • Quality Management System audit experience - Quality performance measurement analysis capabilities (SPC)
  • Six Sigma Green Belt certification
  • 3+ years' of manufacturing and/or integration experience in an aviation/aerospace manufacturing environment
  • Aerospace, space launch, military or commercial aviation preferred - Internal auditing experience - Knowledge of aerospace/aviation / engine manufacturing processes
  • Knowledge of NDE and receiving inspection methodologies - Familiarity with AS9100 or ISO9000 Quality Management Systems and/or related quality systems and programs
  • Provide training and/or assistance to other team members in the use of quality acceptance processes, procedures, and/or tools
  • Serve as a 2nd set of eyes when performing inspections of internal flight hardware. As needed, support the review and inspection of supplier-related hardware
  • Document First Article Inspection Reports for internally produced hardware
  • Monitor SPC activities as necessary
  • Conduct process health assessments and internal audits for compliance with industry standards and provide ongoing objective evaluations of processes and documentation
  • Conduct follow-up and compliance audits to ensure process improvement and corrective/preventive action implementation and effectiveness


  • Kent, United States GTT, LLC Full time

    Quality & Continuous Improvement EngineerContract Duration 6+ MonthsPay range - $48.67 to $59.49/hrJob Description:This Quality & Continuous Improvement Engineer role is part of the Safety, Quality, & Mission Assurance team.This team is focused on monitoring and assessing processes that guide design, manufacture, and operations, ensuring system safety...


  • Kent, United States GTT, LLC Full time

    Job DescriptionJob DescriptionQuality & Continuous Improvement EngineerContract Duration 6+ MonthsPay range - $48.67 to $59.49/hrJob Description:This Quality & Continuous Improvement Engineer role is part of the Safety, Quality, & Mission Assurance team. This team is focused on monitoring and assessing processes that guide design, manufacture, and...


  • Kent, United States GTT, LLC Full time

    Quality & Continous Improvement SpecialistContract Duration 12 MonthsPay range $38.71 - $47.31/hrJob DescriptionOur client is looking for an individual who can support the quality initiatives around flight hardware and engine production.This position will directly impact the history of space exploration and will require your dedicated commitment and detailed...


  • Kent, United States GTT, LLC Full time

    Job DescriptionJob DescriptionQuality & Continous Improvement Specialist Contract Duration 12 MonthsPay range $38.71 - $47.31/hrJob DescriptionOur client is looking for an individual who can support the quality initiatives around flight hardware and engine production. This position will directly impact the history of space exploration and will require your...

  • Quality Specialist

    5 days ago


    Kent, United States SSi People Full time

    Job Title: Quality Specialist IILocation: Kent WADuration: [6+ Months Contract]SummaryWe are looking for an individual that can support the quality initiatives around flight hardware and engine production.This position will directly impact the history of space exploration and will require your dedicated commitment and detailed attention towards safe and...

  • Quality Specialist

    6 days ago


    Kent, United States SSi People Full time

    Job Title: Quality Specialist IILocation: Kent WADuration: [6+ Months Contract]SummaryWe are looking for an individual that can support the quality initiatives around flight hardware and engine production.This position will directly impact the history of space exploration and will require your dedicated commitment and detailed attention towards safe and...


  • Kent, United States ICONMA Full time

    Responsible for implementing quality initiatives that will support development and low rate engine production. This position requires a passion for solving sophisticated problems and providing operable solutions; act with minimal direction and take ownership; and be adaptable as we w...


  • kent, United States ICONMA, LLC Full time

    Responsible for implementing quality initiatives that will support development and low rate engine production.This position requires a passion for solving sophisticated problems and providing operable solutions; act with minimal direction and take ownership; and be adaptable as we w...


  • Kent, United States ICONMA Full time

    Responsible for implementing quality initiatives that will support development and low rate engine production. Check you match the skill requirements for this role, as well as associated experience, then apply with your CV below. This position requires a passion for solving sophisticated problems and providing operable solutions; act with minimal direction...

  • Quality Engineer

    1 month ago


    Kent, United States The Ash Group, Inc. Full time

    6 month Contract W2 ONLY Location: Kent WA Shift: Nights Must be a U.S. citizen or national, U.S. permanent resident (current Green Card holder) to be considered Job Description This role is part of the Safety, Quality, and mission Assurance team. This team is focused on monitoring and assessing processes that guide our design, manufacture, and operations,...

  • Quality Engineer

    1 month ago


    Kent, United States The Ash Group Full time

    6 month contract potential conversion to FTEPay up to $60.50/hr. W2 ONLYLocation: Kent WAOnsiteThis role is part of the Safety, Quality, and Mission Assurance team. This team is focused on monitoring and assessing processes that guide our design, manufacture, and operations, ensuring system safety engineering, environmental health and safety, product...

  • Quality Engineer

    4 weeks ago


    Kent, United States The Ash Group Full time

    6 month Contract W2 ONLYLocation: Kent WAShift: NightsMust be a U.S. citizen or national, U.S. permanent resident (current Green Card holder) to be consideredJob DescriptionThis role is part of the Safety, Quality, and mission Assurance team. This team is focused on monitoring and assessing processes that guide our design, manufacture, and operations,...

  • Quality Engineer

    4 weeks ago


    Kent, United States The Ash Group Full time

    6 month contract potential conversion to FTEPay up to $60.50/hr. W2 ONLYLocation: Kent WAOnsiteThis role is part of the Safety, Quality, and Mission Assurance team. This team is focused on monitoring and assessing processes that guide our design, manufacture, and operations, ensuring system safety engineering, environmental health and safety, product...

  • Quality Engineer

    4 weeks ago


    Kent, United States Insight Global Full time

    Job Description: This role is part of the Safety, Quality, & Mission Assurance team. This team is focused on monitoring and assessing processes that guide design, manufacture, and operations, ensuring system safety engineering, environmental health and safety, product integrity and continuous improvement processes serve the companies Mission and Vision.As...

  • Quality Engineer

    4 weeks ago


    Kent, United States Insight Global Full time

    Job Description: This role is part of the Safety, Quality, & Mission Assurance team. This team is focused on monitoring and assessing processes that guide design, manufacture, and operations, ensuring system safety engineering, environmental health and safety, product integrity and continuous improvement processes serve the companies Mission and Vision.As...

  • Quality Engineer

    2 weeks ago


    Kent, United States AFL Global LLC Full time

    AFL manufactures industry-leading fiber optic cable, connectivity and accessories and provides engineering and installation services for some of the largest telecom customers in the world. Our company was founded in 1984 with a single fiber optic cable and today, we manufacture thousands of products, generate an excess of $1.5B in revenue, and employ...

  • Quality Engineer

    1 month ago


    Kent, Ohio, United States Michael Page Full time

    About Our Client The main products our client manufactures includes hot rolled steel, hot rolled pickle & oil, high carbon & alloy hot rolled. There are over 350 employees in this location and they boast a team-oriented culture, with a clean environment and an emphasis on quality and continuous improvement throughout the company. Job Description Lead...


  • Kent, Ohio, United States Eurofins Lancaster Laboratories Inc. Full time

    Company DescriptionEurofins Scientific is an international life sciences company, providing a unique range of analytical testing services to clients across multiple industries, to make life and our environment safer, healthier and more sustainable. From the food you eat, to the water you drink, to the medicines you rely on, Eurofins works with the biggest...


  • Kent, United States Global Technical Talent Full time

    Production Control Specialist (Level II) Contract Duration 6 Months Pay range - $36.14 to $43.73/hr Job Summary: As part of a diverse and hardworking team of specialists, you will control the manufacturing schedule for various spaceflight systems. You will share in the team's impact on all aspects of manufacturing deliverables. In this role, Production...


  • Kent, Ohio, United States Stryker Full time

    Why RA/QA at Stryker?Are you interested in working for a global company where you can work across functions and on a wide-variety of projects? As a member of Stryker's RA/QA team, that is exactly what you will do Here, we provide our RA/QA team the opportunity to learn new things, as well as endless growth opportunities If you are interested in working at...