GENERAL ENGINEER with Security Clearance

Duties * You will act as the subject matter expert in the design, development, operation and maintenance of Torpedoes that provide offensive and defensive capabilities to the U.S. Navy subsurface and surface Fleets. * You will serve as the Engineering Manager supporting the Torpedoes Technical Warrant Holder. * You will provide scientific, technical and professional engineering advice and guidance on substantive technical aspects of Torpedo programs. * You will perform important engineering work related to coordinating and managing highly complex projects. * You will support Technical Authority and provide subject matter engineering advice and guidance on assigned areas to personnel throughout NAVSEA, NAVAIR, the Warfare Centers, and affiliated PEOs. * You will coordinate and review technical reports and recommendations. * You will provide essential input for approval or disapproval of recommendations that affect major Torpedo systems. * You will oversee the formulation and execution of systems engineering practices on major engineering development, acquisition and in-service programs, adhering to standard systems engineering and technical policy requirements. * You will perform assessment of high-risk high-value technical issues to assess the suitability, effectiveness and safety of Torpedo systems and to determine the range of acceptable solutions, and thresholds for acceptable performance. Requirements Conditions of Employment * Must be a US Citizen. * Must be determined suitable for federal employment. * Must participate in the direct deposit pay program. * New employees to the Department of the Navy will be required to successfully pass the E-Verify employment verification check. To learn more about E-Verify, including your rights and responsibilities, visit e-verify.gov * Within the Department of Defense (DoD), the appointment of retired military members within 180 days immediately following retirement date to a civilian position is subject to the provisions of 5 United States Code 3326. * Males born after 12-31-59 must be registered for Selective Service. * You will be required to obtain and maintain an interim and/or final security clearance prior to entrance on duty. Failure to obtain and maintain the required level of clearance may result in the withdrawal of a job offer or removal. * This position is covered under the Defense Acquisition Workforce Improvement Act (DAWIA). Certification in the Acquisition Functional Area and category assigned to the position is required within established category timeframes. * This position may require travel from normal duty station to CONUS and OCONUS and may include remote or isolated sites. You must be able to travel on military and commercial aircraft for extended periods of time. Qualifications Your resume must demonstrate at least one year of specialized experience at or equivalent to the NH-03 pay band (GS-13 equivalency) in the Federal service or equivalent experience in the private or public sector. Specialized experience must demonstrate the following: As a professional engineer providing expertise in design, development, installation, maintenance or repair of torpedoes and associated torpedo support systems to ensure operation, availability, maintainability and reliability. Additional qualification information can be found from the following Office of Personnel Management website: https://www.opm.gov/policy-data-oversight/classification-qualifications/general-schedule-qualification-standards/#url=List-by-Occupational-Series AND https://www.opm.gov/policy-data-oversight/classification-qualifications/general-schedule-qualification-standards/0800/files/all-professional-engineering-positions-0800.pdf Experience refers to paid and unpaid experience, including volunteer work done through National Service programs (e.g., professional, philanthropic, religious, spiritual, community, student, social). Volunteer work helps build critical competencies, knowledge, and skills and can provide valuable training and experience that translates directly to paid employment. Education Applicants must meet the following basic education requirements of the Office of Personnel Management (OPM) Qualifications Standards Manual: Successful completion of a professional engineering degree. To be acceptable, the program must: (1) lead to a bachelor's degree (or higher) in a school of engineering with at least one program accredited by the Accreditation Board for Engineering and Technology (ABET); or (2) include differential and integral calculus and courses (more advanced than first-year physics and chemistry) in five of the following seven areas of engineering science or physics: (a) statics, dynamics; (b) strength of materials (stress-strain relationships); (c) fluid mechanics, hydraulics; (d) thermodynamics; (e) electrical fields and circuits; (f) nature and properties of materials (relating particle and aggregate structure to properties); and (g) any other comparable area of fundamental engineering science or physics, such as optics, heat transfer, soil mechanics, or electronics. Such education must demonstrate the knowledge, skills, and abilities necessary to do the work of the position. OR Current registration as an Engineer Intern (EI), Engineer in Training (EIT), or licensure as a Professional Engineer (PE) by any State, the District of Columbia, Guam, or Puerto Rico. Absent other means of qualifying under this standard, those applicants who achieved such registration by means other than written test (e.g., State grandfather or eminence provisions) are eligible only for positions that are within or closely related to the specialty field of their registration For more information about EI and EIT registration requirements, please visit the National Society of Professional Engineers website at: http://www.nspe.org OR Evidence of having successfully passed the Fundamentals of Engineering (FE) examination or any other written test required for professional registration by an engineering licensure board in the various States, the District of Columbia, Guam, and Puerto Rico The FE examination is not administered by the U. S. Office of Personnel Management. For more information, please visit: http://www.nspe.org/Licensure/HowtoGetLicensed/index.html. OR Successful completion of at least 60 semester hours of courses in the physical, mathematical, and engineering sciences and in engineering that included the courses specified in the basic requirements under paragraph A (above). The courses must be fully acceptable toward meeting the requirements of an engineering program as described in paragraph A (above) OR Successful completion of a curriculum leading to a bachelor's degree in an appropriate scientific field, e.g., engineering technology, physics, chemistry, architecture, computer science, mathematics, hydrology, or geology, may be accepted in lieu of a bachelor's degree in engineering, provided the applicant has had at least one year of professional engineering experience acquired under professional engineering supervision and guidance. Ordinarily, there should be either an established plan of intensive training to develop professional engineering competence, or several years of prior professional engineering-type experience, e.g., in interdisciplinary positions. Additional information The salary range for Keyport, WA is $136,832 - $191,900 The salary range for Newport, RI is $138,046 - $191,900 This position is part of the Department of Defense Civilian Acquisition Workforce Personnel Demonstration Project. The NH-4 broadband level encompasses positions equivalent to GS-14 and GS-15. The salary range shown in the announcement represents all of the positions within the NH-4 broadband level, however the salary range for this position is capped at GS-15, step 5, currently $184,026 in Rhode Island and $182,408 in Washington. If your current salary is above this amount, your salary may be matched. This position is covered by the Department of Defense Priority Placement Program. Additional vacancies may be filled by this announcement. A tentative offer of employment will be rescinded if the selectee fails to meet the pre-employment requirements, including failure to report to any of the scheduled appointments. Federal annuitant information: The selection of an annuitant is subject to the Department of Defense and Department of the Navy policy on the employment of annuitants. Policy information may be found at: http://www.secnav.navy.mil/donhr/Documents/CivilianJobs/FedCivAnnuitants.pdf PPP applicants will be placed at the FPL, if determined Well Qualified (WQ). To receive priority consideration, the FPL must be the same grade level or equivalent of the retained grade or the grade held immediately prior to separation. ICTAP Applicants: To be considered well-qualified and exercise selection priority as an ICTAP candidate, displaced Federal employees must satisfy all qualification requirements for the position and receive a rating in the highly qualified category (score 85) or higher. ICTAP candidates must provide copies of all of the following documentation at the time of application: 1) agency notice; 2) most recent performance appraisal; and 3) most recent SF-50 or notification of personnel action that includes position, grade level, and duty location. Applicants who do not provide this documentation will not receive consideration as an ICTAP candidate. For more information about ICTAP eligibility please review the following link: https://www.usajobs.gov/Help/working-in-government/unique-hiring-paths/federal-employees/career-transition/ Military Spouse Preference applicants will be placed at the highest grade for which they have applied and are determined Best Qualified (BQ). A BQ military spouse possesses knowledge, skills, abilities, and competencies comparable to others who meet the competitive referral criteria for the specific position. * Benefits Help A career with the U.S. go